Questa pagina non è ancora tradotta; è mostrata in inglese.
Hotspot and host connections
DM32+ communicates with a computer through the USB-to-serial programming cable. Close CPS and the installer before another application opens the port. The cable's USB interface belongs to the adapter; the radio itself is not a USB serial device or USB network adapter.
DMR hotspot
Hotspot mode presents an MMDVM DMR modem to a host such as MMDVMHost. Enable Settings > Connections > Hotspot allowed. Configure the host for the cable's serial port, UART at 115200 baud, simplex DMR, and the intended frequency and color code. Enable network slot 2 and disable slot 1. The firmware carries DMR frames between the host and RF; it does not need the AMBE codec for this mode.
The radio enters hotspot mode when the host sends its MMDVM requests. The hotspot screen shows state, frequency, power, and the current or last call. Use Tools & Utilities > Hotspot for status and the stop action. The host can transmit when connected, so check its configuration before starting it.
Serial networking
The firmware implements PPP networking over the programming UART. This requires a configured PPP peer on the computer; plugging in the cable does not create a network adapter automatically. Browser CPS and PPP cannot own the same serial port at the same time.
The PPP specification describes setup and the services carried over that link. USB-network instructions for CDC-NCM adapters, USB mode switching, and native-USB discovery do not apply to this radio.
Advanced repeater modes
Single-frequency repeater behavior and split duplex operation have additional configuration and hardware requirements. They are not the same as a simplex hotspot. Consult the SFR specification, split-duplex specification, and hardware verification record before experimenting.