Install and Back Up

Install, update, back up, and restore DM32+ through the programming cable. Use Chrome or Edge on a computer.

Before installing DM32+

Review the selected firmware release and back up your radio before installing. Hardware verification and known limitations are documented in the manual.

What Can Go Wrong

Your radio can always be recovered. The installer never writes the radio's bootloader, so a radio that stops working can always be installed again or restored to the manufacturer's firmware.

If Something Goes Wrong

If an operation fails, download a problem report and attach it to an issue in the project repository.

Common Questions

What testing has been done?
  • On real radios: Each new version runs on actual radios connected to a hardware test bench (hardware-in-the-loop testing), which checks the features you use every day automatically.
  • With other DMR equipment: Each version is checked on each supported radio, over the air, against repeaters, handhelds and hotspots. An SDR (software-defined radio) receiver captures the precise timing and contents of every transmission and compares it bit for bit with the ETSI DMR standard, the specification every DMR radio follows.
  • The installer: Every step of this installer is rehearsed against simulated radios, including slow cables, dropped connections and damaged transfers.
  • Every screen: A simulator of the radio's display draws and steps through the firmware's menus and screens.
  • Every code change: Unit tests (small automated checks of each part of the software) run on every change, and the firmware is built for every supported radio before anything is released.

How DM32+ is tested

Can the installer damage my radio?

Not permanently. The radio's bootloader, the part that lets it be installed again, is never written to, and every installation is checked once it has been written. If an installation stops partway, put the radio in its bootloader and install again, or restore your backup or a supported manufacturer firmware file.

What to do if something goes wrong

What happens to my channels and settings?
  • Backup: The installer saves a backup file before or right after the installation, depending on the radio. Not every radio supports every kind of backup, so the backup step shows what yours can save (the original firmware, channels and settings, factory calibration) and how long each takes.
  • Your original channels: DM32+ organizes channels differently from the manufacturer's firmware, so they don't carry over by themselves. For some radios, the Codeplug Editor on this site can convert them from the backup file.
  • Updates: Updating DM32+ later keeps your channels and settings.
How quickly are problems fixed?

Website fixes appear after the site is updated. Firmware fixes are included in a published release; review its release notes before updating.

How can I give feedback?

Use Report a Problem to download the installer log, then attach it to a GitHub issue with the firmware version and steps to reproduce the problem.

Loading…